TA-Technix Camberjusteringsplater - VW New Beetle

From Year 1996 -
Change / angle to -1°
Mounting on the rear axle, enables a change in the camber
Mounting between rear body and journals
Only for models with front-wheel drive
1 Set = 2 pieces

From year 1996 -
Change / angle to +0,5° degrees
Mounting on the rear axle, enables a change in the camber
Mounting between rear body and journals
Only for models with front-wheel drive
1 Set = 2 pieces

From year 2003 -
By installing the brace is a negative camber
Models with multi-link rear axle
2 pieces = 1 Set

From year 1996 - 2010
By exchanging the ball joints are appropriate corrections of approximately +/- 1-2 ° are invalid.
Depending on the setting, an additional lowering of approximately 10-15mm is achieved by the altered axle geometry.
This kit is particularly suitable for air (airride) / - coilovers, round / - slaloms.
Does not fit into cast steel control arms
Camber / - caster adjustment at the front axle for following model.
2 pieces / 1 set

Technical information:
From year 1997 - 2010
Dimension of the center bar: 385mm
3-piece adjustable,
Threaded adjustable on both sides
Approx 35mm
Mounting above and below possible
Adjustment range: about -2 ° to + 2 °
Color: blue matt
Socket with polyurethane seal
Rear axle

With camber / - caster adjustment / lowering (-10mm)
1 Set = 2 pieces
Front axle on both sides
From year : 1996 -

With camber / - caster adjustment
1 Set = 2 pieces
From year : 2003 -